Библиотека сайта или "Мой Linux Documentation Project"
A floppy disk consists of a flexible membrane covered on one or both sides with similar magnetic substance as a hard disk. The floppy disk itself doesn't have a read-write head, that is included in the drive. A floppy corresponds to one platter in a hard disk, but is removable and one drive can be used to access different floppies, and the same floppy can be read by many drives, whereas the hard disk is one indivisible unit.
Like a hard disk, a floppy is divided into tracks and sectors (and the two corresponding tracks on either side of a floppy form a cylinder), but there are many fewer of them than on a hard disk.
A floppy drive can usually use several different types of disks;
for example, a 3.5 inch drive can use both 720 KB and 1.44 MB disks.
Since the drive has to operate a bit differently and the operating
system must know how big the disk is, there are many device files
for floppy drives, one per combination of drive and disk type.
/dev/fd0H1440 is the first floppy
drive (fd0), which must be a 3.5 inch drive, using a 3.5 inch, high
density disk (H) of size 1440 KB (1440), i.e., a normal 3.5 inch HD
The names for floppy drives are complex, however, and Linux
therefore has a special floppy device type that automatically
detects the type of the disk in the drive. It works by trying to
read the first sector of a newly inserted floppy using different
floppy types until it finds the correct one. This naturally requires
that the floppy is formatted first. The automatic devices are called
/dev/fd1, and so
The parameters the automatic device uses to access a disk can also be set using the program setfdprm . This can be useful if you need to use disks that do not follow any usual floppy sizes, e.g., if they have an unusual number of sectors, or if the autodetecting for some reason fails and the proper device file is missing.
Linux can handle many nonstandard floppy disk formats
in addition to all the standard ones. Some of these require using
special formatting programs. We'll skip these disk types for now,
but in the mean time you can examine the
/etc/fdprm file. It specifies the settings
that setfdprm recognizes.
The operating system must know when a disk has been changed in a floppy drive, for example, in order to avoid using cached data from the previous disk. Unfortunately, the signal line that is used for this is sometimes broken, and worse, this won't always be noticeable when using the drive from within MS-DOS. If you are experiencing weird problems using floppies, this might be the reason. The only way to correct it is to repair the floppy drive.
Только зарегистрированные пользователи могут оценивать и комментировать статьи.